FREQUENTLY ASKED QUESTIONS 

How Do I apply my vinyl graphic sticker to my car?

How do I make a Sand Art Picture?

-This vinyl sticker is in three parts and is self adhesive.

• The top layer is called the Application Tape, this holds pieces of your design together for easy application after the backing paper is removed.
• The middle layer is the final product, the actual vinyl sticker
• The bottom layer is the backing paper

Preparation
• Thoroughly clean the surface. The surface you are applying the sticker to, must be clean, dry & free of any dust or residue. (Pure soap, water & a
lint free cloth is best)
• After preparing surface, check that the sticker fits in place. If necessary, cut of any excess application & backing paper & make guidelines with
masking tape or a non-permanent marker.

Application
• You can apply this vinyl sticker wet or dry. To apply wet mix a very small amount of dish soap with water and spray on surface. This will help
maneuver the sticker into place.
• Carefully remove the backing paper from the sticker. Ensure that no part of the design remains on the backing paper.
• Position one edge of the sticker onto the prepared surface.
• Slowly roll the sticker onto the surface, rubbing it down with the edge of your hand as you go.
• Using a credit card or something similar, squeegee from the middle to the outer edges.

Remove Application Tape

Wait for 10 to 20 minutes and then remove the application tape. Allowing this time will ensure that the decal will adhere to the surface fully. Slowly remove application tape, ensuring that the sticker does not lift with the tape. Air bubbles will usually disappear after a few weeks, if not, you use a pin to puncture the vinyl and squeeze the air by pushing down with your thumb

 Sand Art Pictures

SIMPLE STEPS TO MAKING A SAND ART PICTURE
Starting with darker colors will create a neater picture.  White sand should always be used last. 

1.  Place your card on top of paper to catch the excess sand.
2.  Lift a cut section using the tip of a bamboo lifter and slowly peel off the first area. Take care not to lift adjoining areas.  For small sections use a pin
3.  Now choose a colour and pour it over the sticky area. Turn the card over and tap it on the back to remove the excess sand.
     ****Repeat the pouring process on the same area to obtain a darker shade.
4.  Peel off the next area. Pour a different colour and repeat the motion until the image is completely peeled off and coloured.